configure-pfsense [Privatise Knowledgebase]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

==== Configuring the pfSense Interface ====

Enter a preshared key. You can use an online generator to create one. Please save this preshared key.

=== Experimental, use with care ===

1. Go to VPN -> IPsec

2. Select +Add P1

Key Exchange Version: IKEv1


Internet Protocol: IPv4


Interface: <Your pfSense WAN Interface>


Remote Gateway: Privatise ROC IP Address


Authentication Method: Mutual PSK


Negotiation Mode: Main


Peer Identifier: Peer IP Address


Pre-Shared key: the same key you generated earlier.


Encryption Algorithm


Algorithm: AES


Key Length: 256 bits


HASH: SHA1


DH Group: 2


Lifetime (Seconds): 86400


**Advanced Options
**


Disable rekey: Unchecked


Margintime (Seconds): Empty


Responder Only: Unchecked


NAT Traversal: Auto


Dead Peer Detection: Checked


Delay: 10


Max failures: 5


**Select Save.
**

3. +Add P2

Mode: Tunnel IPv4

Local Network: Network: Put your local LAN network subnet

Remote Network: Network: 10.12.0.0/24 (10.12.0.0 255.255.255.0).

Phase 2: Proposal

Protocol: ESP

Encryption Algorithm-AES: 256bits

Hash Algorithms: SHA1

PFS Key Group: 2



=== Bringing the tunnel up ===

1. In the Menu Bar go to Status:-> IPsec

2. On the tunnel, you created select: Connect VPN