This is an old revision of the document!
* UBUNTU *
–
sleep mode issue
If you have any issues with Privatise after sleep mode. 1. After sleep, go to the terminal where Privatise is running and hit "CTRL + C" to terminate. 2. Restart Privatise with sudo openvpn /etc/openvpn/client/client.ovpn.
while connecting through VPN, automatically it is disconnecting again and again
1. Go to sudo nano /etc/openvpn/client/client.ovpn. 2. Change the number 1194 to 443, and the word UDP to TCP. 3. Restart Privatise after typing ctrl + c with sudo nano /etc/openvpn/client/client.ovpn.
The connection might be a bit slower, but you shouldn't have an issue with disconnects after that.
WiFi disconnect over Privatise
1. Run sudo apt-get install -y resolvconf. 2. Reboot after running and finishing the install of resolvconf and try running Privatise again.
AEAD Decrypt error: bad packet ID
Please stop Privatise and try the following 1. Open the client config: sudo nano /etc/openvpn/client/client.ovpn. 2. Change the following lines: Where it says proto udp. Please change this to proto tcp. Where it says remote xxx.xxx.xxx.xxx 1194 . Please change this line to remote xxx.xxx.xxx.xxx 443 .
Issues related to Google Meet
Please do the following: 1. sudo nano /etc/openvpn/client/client.ovpn. 2. Add the following line as a new line at the bottom: route 142.250.82.0 255.255.255.0 net_gateway 3. Save the file. 4. Restart Privatise on the terminal it's running on with. 5. ctrl C 6. then restart with: sudo openvpn /etc/openvpn/client/client.ovpn
Lost internet access after a restart of Privatise or closing of Privatise
Please do the following: 1. sudo service network-manager reload.